Instructions for Water-Filling Mobile Toilets

The instructions for using water-filling mobile toilets vary depending on the type. Here are the usage methods for common types:

Mobile Eco-Friendly Public Toilet (Water Flush)

1. Water Source and Pressure: Choose a water supply point with clean water and sufficient pressure to ensure effective flushing.
2. Winter Freeze Protection: Turn on the heating cable and electric heater before use. When not in use, drain the water from the water tank, inlet pipe, washbasin, and squat toilet. Release water through the toilet's water inlet valve, and the booster pump should be drained separately.
3. Equipment Power Matching: For the exhaust fan (20w), light (20w), electric heater (300w), and heating cable (10w/meter), select the appropriate wire gauge according to the configuration.
4. Sewage Maintenance: For pipe-discharge public toilets, flush the sewage pipes with a high-pressure water gun every 20-60 days (20 days in winter and 60 days in summer) to prevent blockages.
5. Lifting Sealing: After lifting, reapply sealant at the lifting points to prevent rain leakage on rainy days.
6. Pipe Specifications: The sewage outlet is 110mm (a 250mm pipe hole can be made in the septic tank for direct discharge), the washbasin drain outlet is 50mm (a 160mm pipe hole can be made in the septic tank), and the inlet pipe diameter is 33mm.

Independent Mobile Toilet

1. Installation and Connection: After fixing the toilet, connect the sewage hose to the floor drain or sewage bucket, connect the inlet pipe to a clean water source and open the valve, and check the interface seal after plugging in the power.
2. Function Operation: After turning on the power, the flush button controls the amount of flushing water (dual-flush models distinguish between urine and feces). The heated seat can adjust the temperature, and the deodorization function can be activated automatically or manually.
3. Maintenance and Cleaning: When the sewage tank is full, turn off the power, pull it out horizontally, empty it, and rinse it. Disinfect the shredding blade area with a special cleaner every month. Clean the fresh water tank weekly to prevent algae growth. Avoid throwing in anything other than tissue paper, protect against freezing in winter, and drain the water tank for long-term storage.

Mobile Toilet Seat

1. Water Filling Preparation: Separate the toilet into a fresh water tank and a sewage tank. Add a degrading agent (50-120 ml for 21 liters of sewage) and 100 ml of water to the sewage tank, close the partition, and then fill the fresh water tank.
2. Usage Process: Open the sewage tank partition during defecation, use the hand pump to clean after use, and push the partition back to continue using.
3. Sewage Tank Cleaning: After separation, tighten the partition, tilt the sewage tank and press the air relief valve to empty it, rinse it with clean water, and then add the degrading agent again.