Xuchang Mobile Toilet Installation

The installation of mobile toilets in Xuchang should follow standardized procedures, covering pre-installation preparation, foundation installation, zoning setup, lighting installation, acceptance inspection, post-event removal, and follow-up services to ensure safety, practicality, and environmental protection.

Pre-Installation Preparation

1. Site Survey: Confirm the locations of key areas (such as start/finish lines and rest stops) with the event organizer, avoid areas with dense drainage pipes, reserve a 1.5-meter safety passage, and confirm the site's water supply, drainage conditions, and terrain adaptation plan.
2. Requirement Confirmation: Determine the number of toilets to rent based on the event scale (number of participants and duration) (it is recommended to provide 1-2 toilets per 100 people), and clarify the rental price, installation/removal time, and scope of maintenance services (such as cleaning and fault repairs).

Foundation Installation Specifications

1. Ground Treatment: Hard ground should be leveled and compacted. For soft ground, steel plates should be laid or heavy-duty bases should be used, and anti-slip mats should be laid to prevent water accumulation.
2. Fixing Method: Use expansion screws or counterweights to secure the toilets and prevent them from being blown over by the wind.
3. Water and Electricity Connection: Connect the sewage pipes to the municipal sewer network or designated collection points. Direct discharge into natural water bodies is prohibited. The power supply area should be kept away from water sources, and the wire joints should be wrapped with insulating tape to prevent short circuits.

Zoning Setup Principles

1. Start/Finish Area: Provide 1 toilet per 500 participants.
2. Along the Race Track: Set up 1 toilet every 2 kilometers, with a male-to-female ratio of 1:1.5.
3. Near Medical Stations: Add accessible toilets to meet special needs.
4. Activity Area: The toilets should be within a 30-meter walking distance from the activity area, avoiding extreme terrains such as low-lying areas and windy spots to ensure privacy and safety.

Lighting System Installation (if required)

1. Selection Principles: Prioritize low-voltage LED fixtures (with an IP65 or higher protection rating) that balance safety, energy efficiency, and waterproof and dustproof capabilities.
2. Installation Steps: Drill holes in the top or side walls of the toilet to fix the fixture brackets, connect the power supply according to the instructions (pay attention to the color coding of the live wire, neutral wire, and ground wire), and install waterproof or remote-controlled switches.

Installation Acceptance Inspection Points

1. Appearance Cleanliness: No damage or stains, and clear markings.
2. Function Testing: The flushing, lighting, and ventilation systems should operate normally.
3. Emergency Preparedness: Provide spare toilet paper and hand sanitizer, and set up a cleaning tool room.

Post-Event Removal Process

1. Empty and disinfect the waste.
2. Remove the fixing devices and load them onto the transport vehicles in an orderly manner.
3. Restore the site to its original condition and clean up any remaining garbage.

Other Recommendations

1. Choose a regular service provider with local service experience.
2. The service provider should clean the toilets at least once a day, and increase the frequency during peak times.
3. Communicate in advance about the allocation of spare toilets to cope with sudden increases in the number of participants or equipment failures.