How to Use Water in Urban Mobile Toilets

The water usage methods for urban mobile toilets vary depending on their types, as detailed below:

Water-flushing mobile toilets: This is a relatively common type, usually equipped with a water tank, which is generally installed on top of the toilet. After a user finishes using the toilet, pressing the flush button or pulling the handle will cause the water in the tank to flow through pipes into the toilet bowl, flushing away the waste. Subsequently, the mixture of waste and water will be discharged into a sealed storage tank below. Some that are connected to municipal sewage treatment pipes will discharge directly into the pipes. Some high-end water-flushing mobile toilets are also equipped with a recirculating water system. This system filters the used water, enabling the filtered water to be reused for flushing, thereby improving water resource utilization.

Waterless-flushing mobile toilets (partially relying on a small amount of water): Although referred to as "waterless-flushing," some models of this type of mobile toilet actually still require a small amount of water. During use, they are used in conjunction with degrading agents. The small amount of water is mainly used for flushing, while the degrading agents effectively reduce odors and keep the air inside the toilet fresh.

Plastic mobile toilets: The water preparation for this type of mobile toilet is relatively more complex, requiring tools and materials such as water pipes, faucets, buckets, and water pumps. It usually has two water inlet points: one for the flushing tank and one for the sink. When in use, the water pipe should be connected to the faucet. If the water source is far away, a water pump is needed to draw water. After turning on the water source, the flow rate and intensity of the water can be controlled through the faucet switch or regulating valve. At the same time, the water level in the flushing tank should be adjusted according to the actual situation to ensure good flushing performance. Finally, it is necessary to carefully check whether the water flow is smooth and whether there are any leaks at the connection points.