Installation Method of Portable Toilets

The installation method of portable toilets should be selected according to the specific type. Common types include general-purpose portable toilets and simple mobile toilet devices, with specific installation methods as follows:

I. Installation of General-Purpose Portable Toilets

1. Tool Preparation
   Prepare tools such as an electric drill, a 4.2-millimeter drill bit, a rivet gun, and a spirit level in advance. Ensure that the installation site has a flat ground and a power outlet (if electricity is required). For products with composite structures or those that are hoisted, confirm that the site's load-bearing capacity meets the requirements.

2. Main Body Assembly

   • Frame Fixation: Fix the inner corner pieces on the ground or base in sequence according to the design drawings. Use a spirit level to adjust the verticality to avoid misalignment during subsequent assembly.
   • Panel Assembly: Insert the prefabricated panels into the slots, align the edges, and mark the drilling positions with a marker pen. Some products have locating pins in the slot design, ensuring that the pin holes are fully aligned.
   • Riveting Fixation: Drill holes at the marked positions with a 4.2-millimeter drill bit, insert rivets, and use a rivet gun to complete the fixation. For products with composite structures, reinforce the corners and load-bearing parts to prevent deformation during long-term use.

3. Functional Module Connection
   If equipped with sewage discharge, ventilation, or power supply systems, connect the pipes and wires according to the instructions. For hoisted toilets, install lifting rings in advance. For towed toilets, confirm that the towing device matches the vehicle.

4. Simplified Process for Factory Pre-assembly
   Some manufacturers complete the assembly of the frame and panels before leaving the factory. Users only need to check the alignment of the slots and proceed directly with riveting fixation, which can shorten the installation time by approximately 30%.

II. Installation of Simple Mobile Toilet Devices

1. Accessory Inspection
   After unpacking, check whether the main body, water tank, sewage pipe, sealing ring, and other accessories are complete. Inspect the surface for scratches or cracks. If any accessories are missing or damaged, contact the manufacturer immediately for replacement.

2. Main Body Assembly

   • Base Fixation: Place the base at the predetermined position and fix it with expansion screws or anti-slip pads to ensure stability.
   • Toilet Installation: Align the main body of the toilet with the buckles on the base, press gently until fully fitted, and install the sealing ring to prevent leakage.

3. Component Connection
   Connect the water inlet pipe of the water tank and the sewage pipe, ensuring that the joints are wrapped with Teflon tape or sealed with special sealant. For towed devices, install brake devices and indicator lights to comply with road safety standards.

Precautions: Portable toilets are classified into single-unit and composite structures based on their structure and into hoisted and towed types based on their mobility. Different types have varying requirements for installation sites and tools. It is recommended to contact the manufacturer before installation to confirm the installation requirements for the specific model to avoid equipment damage or safety hazards due to improper operation.