How to Move the Toilet During Bathroom Renovation

Moving the toilet position during bathroom renovation can be achieved through the following methods:

1. Using same-diameter drainpipe modification
This method requires first confirming the new toilet position, drawing a straight line from the original toilet hole on the floor to the new position, installing elbows along the line, connecting with a pipe of the same diameter as the original drainpipe, and finally using a 90-degree elbow to close the end and connect to the main drainpipe. The advantage of this solution is that the pipe diameters are consistent, resulting in low water flow resistance and less likelihood of blockage. However, it should be noted that after construction, the bathroom floor will be raised by 15 to 20 centimeters overall, which may affect space usage or the connection with other areas, so planning for floor material transitions in advance is necessary.

2. Using a dedicated toilet offset flat pipe for modification
When constructing, first determine the new position, cut the floor and create a groove along a straight line. The groove depth must be strictly controlled below the floor slab reinforcement layer to avoid damaging structural safety. After cleaning debris from the groove, lay a dedicated flat pipe to connect the old and new drain outlets. This method does not require raising the floor and is suitable for scenarios with high ceiling height requirements. However, the offset distance must be precisely calculated (usually not exceeding 1 meter), and the bends in the flat pipe must remain smooth; otherwise, the risk of blockage may increase.

3. Offset connector method
This is suitable for small-scale, short-distance offsets (usually 10-30 centimeters, with a maximum of 40 centimeters), achieved by installing an offset connector between the original drain outlet and the new position. Its advantages include minimal modifications, low cost, and a short construction period. However, it should be noted that the offset connector will change the drainage path, which may affect flushing performance, especially for siphon-type toilets. A slope of 1%-3% must be reserved during construction to ensure smooth sewage discharge; otherwise, blockages may occur.

4. Floor raising method
If the offset distance is short (relatively safe within 10 centimeters), the drainage slope can be adjusted by simply raising the floor. If the offset exceeds 20 centimeters, the entire floor must be raised by at least 12 centimeters to create sufficient pipe slope. This method requires designing steps or ramps in conjunction with the overall renovation style to avoid affecting usability, while ensuring the structural stability of the raised section to prevent cracking or settling after long-term use.