Outdoor Mobile Toilet Assembly

The assembly methods for outdoor mobile toilets vary depending on the product type and merchant services, and the appropriate method should be selected based on specific structural characteristics. Here are detailed instructions on the assembly points for different types of mobile toilets and the assembly process in Luzhou area:

I. Assembly of Frame-Structured Mobile Toilets
Take the 30-square-meter Apple Cabin toilet produced by Dezhou Hongtu Metal Products Co., Ltd. as an example. It features a galvanized frame structure with an exterior wall made of imitation wood-grain metal carved panels. During assembly, priority should be given to completing the frame construction, ensuring that the verticality and levelness of the galvanized steel pipes meet design requirements, and using dedicated connectors to secure the frame nodes. When installing the exterior wall panels, attention should be paid to the consistency of the texture direction of the metal carved panels. The panels should be fixed to the frame using clips or rivets, and 2-3 millimeter expansion joints should be reserved between the panels to accommodate temperature changes. Internal facilities such as water tanks and sewage pipes should be pre-installed before the frame is enclosed to ensure that the pipe slope meets drainage requirements.

II. Assembly of Modular Mobile Toilets
For a four-squat-position mobile toilet (4 meters long and 2.3 meters wide), its exterior wall is made of thermal-insulating metal carved panels, and the roof has a pointed design. During assembly, the bottom base should be fixed first to ensure that the equipment is placed horizontally. The pointed roof structure should be installed in sequence according to the numbers, using self-tapping screws to secure the metal roof panels, and attention should be paid to the design of the roof drainage slope. The squat positions and urinals inside should be positioned according to the design drawings and fixed to the ground using expansion bolts. The sewage pipe connections should use rubber seals to prevent leakage. The installation of metal carved panels should adopt a hidden clip design to avoid the impact of exposed screws on aesthetics.

III. Characteristics of the Assembly Process in Luzhou Area
The assembly process for mobile public toilets in Luzhou area is relatively simplified, and merchants usually provide on-site installation services. Users need to prepare tools such as an electric drill (with a 4.2-millimeter drill bit) and a rivet gun. The assembly process is divided into three steps:

1. Inner Corner Installation: Use an electric drill to drill holes at the frame connections and secure the inner corner pieces with rivets to ensure structural stability;
2. Panel Assembly: Insert the metal carved panels into the frame slots and assemble them in a "bottom-up" sequence. Use sealant to treat the joints between the panels;
3. Fixing and Reinforcement: After aligning the panels, drill holes at the reserved positions and install rivets, focusing on reinforcing the stressed parts such as doors and windows.
   This process does not require complex welding or cutting operations, and ordinary users can complete the basic assembly under the guidance of technicians.

IV. General Precautions for Assembly
For the assembly of all types of mobile toilets, attention should be paid to the following:

• Before assembly, check the completeness of the components and verify the design drawings against the actual part numbers;
• Apply anti-rust paint to the contact surfaces of metal components to extend their service life;
• Conduct a water flow test on the sewage pipes to ensure there is no blockage or leakage;
• After assembly is complete, perform an overall level calibration to avoid equipment tilt affecting use.