How to Install a Mobile Toilet Seat

The installation of a mobile toilet seat can be carried out according to the following steps:

1. Check the accessories and sewage pipes
   After receiving the mobile toilet seat, first open the package and carefully check the accessory list to ensure that all components (such as the toilet body, flange, angle valve, water inlet hose, nozzle, sealing gasket, etc.) are complete and undamaged. Then conduct a comprehensive inspection of the sewage pipes to confirm that there are no obstructions such as sand or waste paper inside, preventing drainage problems after installation. At the same time, check whether the ground around the toilet installation position is level. If the ground is uneven, use cement or self-leveling materials for leveling to ensure good stability of the toilet after installation.

2. Install the toilet flange
   The flange is a key component that connects the toilet to the sewage pipe, serving to seal and prevent odor leakage. Place the flange above the sewage pipe opening, adjust its position so that the center of the flange aligns with the center of the sewage pipe, and ensure that the edge of the flange fits tightly against the ground. Then slowly lower the toilet so that the toilet's sewage outlet fully matches the flange, and gently press around the toilet to secure it.

3. Connect the water inlet system
   Install the angle valve and connect the water inlet to the tee of the nozzle. First, fix the angle valve at the water inlet on the wall and tighten the connecting threads to prevent water leakage. Connect one end of the water inlet hose to the angle valve and the other end to the toilet's water inlet. Be sure to install a sealing gasket at the interface and tighten it to avoid water leakage. When assembling the toilet nozzle, connect the nozzle to the other end of the tee, also install a sealing gasket and tighten it. Finally, firmly clamp the nozzle holder onto the top of the tee to ensure that the nozzle is firmly fixed.

4. Test the water and apply sealant
   After completing the connection of the water inlet system, open the angle valve to test the water. Check whether the toilet's flushing function is normal and observe whether there are any water leaks at the connections. If there are no problems during the water test, evenly apply waterproof glass sealant around the gap between the bottom of the toilet and the ground to serve as a fixing and sealing function, preventing odor from escaping through the gap. After applying the sealant, wait for more than 24 hours for the sealant to fully cure before using the toilet.