Quay lại blog
Bài viết

Mobile Toilet Circuit Diagram Translation

Quản trị 20 tháng 9, 2026

Currently, there is no complete circuit diagram for mobile toilets, but a detailed description of the relevant circuit principles can be provided, mainly including two parts: the power supply architecture of mobile public toilets in expressway service areas and the circuit principle of the automatic flushing controller for public toilets.

Power Supply Architecture of Mobile Public Toilets in Expressway Service Areas: The power supply system of mobile public toilets is centered around a controller. After connecting to a 220V AC power source, it is converted into DC power (usually 12V or 24V) through an AC-DC module. The converted DC power supplies various devices, including presence/absence indicator signs, ceiling-mounted speakers, exhaust fans, toilet stall human body sensors, lighting fixtures, and smart locks for partition doors. These devices are connected to the controller via IO signals, enabling centralized control and management. For example, when a human body sensor detects someone entering a toilet stall, it sends a signal to the controller, which then turns on the lighting fixture and starts the exhaust fan; when no one is present, the corresponding devices are turned off to achieve energy conservation and intelligent management.

Circuit Principle of the Automatic Flushing Controller for Public Toilets: The core function of this circuit is to flush the toilet at regular intervals through a solenoid valve, with different flushing intervals during the day and night, and it also has a manual control function. Its power supply circuit consists of a transformer T, VD1 to VD4, VD5, and C1, providing 12V DC power. The control core is an NE555 timer circuit, which, together with surrounding components, forms a pulse signal oscillator with an automatically adjustable duty cycle. When the power is turned on, C2 charges through R1 and VD6, with pin 2 of the IC at a low level and pin 3 at a high level, energizing the solenoid valve to release water. The charging time is approximately 10s, and the flushing time is also about 10s. After C2 is fully charged, pin 3 goes low, VS turns off, and C2 begins to discharge. During the day with light, the resistance of the photosensitive resistor R2 is 5kΩ, and the discharge time of C2 is 15 minutes; at night without light, the resistance of R2 changes to 5MΩ, and the discharge time of C2 is 1 hour. After the discharge is complete, pin 3 of the IC goes high again, VS turns on, and the solenoid valve is energized to release water again, repeating this cycle to achieve timed flushing. In the diagram, S is a manual control switch that can be used to manually control the flushing. In this circuit, the IC is an NE555 timer circuit, VS is a 3A/600V bidirectional thyristor, and R2 is an MG-43 type photosensitive resistor.