DIY Mobile Toilet

There are mainly three methods for making DIY mobile toilets: using a water storage bucket, discarded tiles, and a combination of a water storage tank and a pallet.

Making with a water storage bucket: First, take out a water storage bucket from home and split it in half with an angle grinder. Fix universal wheels at the four corners of a wooden board for easy mobility. Take wooden strips and fix them on the upper side of the bucket with self-tapping screws to increase the height. Cut an opening on the side of the water storage bucket, install sponge strips on both sides of the opening to form a door frame, and insert plastic soft boards between the wooden strips to create an elevated wall. Place the upper half of the water storage bucket on top of the wooden strips as a roof. To enhance aesthetics, paint the wooden strips with white waterproof paint. Use foam strips to piece together discarded honeycomb wooden boards to make a simple door. Cut a hole at the bottom of the bucket and install a drain pipe to form a floor drain. Drill holes on the side and bottom of a plastic bucket and connect them with direct fittings. Place the plastic bucket on the roof to form a small water storage device. Connect a water pipe-made bath heater, install a tee under the water inlet pipe, and connect a showerhead. Place a toilet and install a water tank. Fix the toilet with glass glue, connect the drain pipe to the sewage bucket, horizontally connect a water pipe from the tee on the outlet pipe to the door as the water inlet pipe for the sink, and drill a hole in the door and install a fitting.

Making with discarded tiles: First, place the toilet on the tile. Use a ruler to draw a red marking line along the edge of the toilet. Move the toilet away and cut out a rectangular tile piece slightly larger than the bottom of the toilet with an angle grinder along the marking line. Turn the rectangular tile over and place universal wheels at the four corners. Draw marking points with a marker pen, drill screw holes with an electric drill, realign the universal wheels with the screw holes, insert screw rods, and tighten the nuts to fix them. Use an angle grinder to cut off the protruding screw rods on the back of the tile. Put the toilet back on the tile, draw a marking line along the edge of the toilet, and mark the position of the sewage outlet at the bottom of the toilet connected to the sewer. Insert a hose from the bottom of the tile and fix one end. Apply white cement along the marking line on the tile and place the toilet on it according to the marking line so that the toilet and the tile are glued together with the cement. Move the toilet with the installed base to the bathroom, install a water tank above the toilet, and tighten it with plastic fasteners to secure it. Cover the water tank lid, install the toilet seat cover, put the sewage hose into the drain pipe, connect the water inlet pipe to the water tank.

Making with a water storage tank and a pallet: Take out a plastic pallet and fix a universal wheel at each of the four corners at the bottom of the pallet with tools. Subsequently, the main structure of the toilet, such as installing a toilet and a water tank, can be further built on this basis.