Relocation of Toilet Sewage Pipes

Toilet sewage pipes can be relocated, primarily through methods such as toilet offset connectors, raising the floor to relay pipes, and on-site operations by plumbers. Details are as follows:

Using a toilet offset connector is a relatively common method. Also known as a deflector or sewage offset connector, it is a pipe fitting used for toilet installation. It is mainly used to solve the issue where the reserved sewage outlet in the bathroom does not align with the toilet's sewage outlet, preventing proper connection. It can change the front-to-back or left-to-right position of the drain outlet. For short-distance relocations (within 40 centimeters), it is recommended to use a dedicated flat offset connector or round pipe. During installation, maintain a slope of 1%-2% to ensure smooth drainage of sewage, and reduce the number of bends, as excessive bends can easily lead to blockages.

If the relocation exceeds 40 centimeters, it is necessary to raise the floor by 20 centimeters and relay the pipes. Although this method involves a relatively large amount of work, it can meet the needs of relocations over longer distances.

On-site operations by plumbers are also a crucial part of relocating sewage pipes. Specific steps include cutting off the excess part of the sewage pipe to ensure the appropriate pipe length; fitting a sealing ring to ensure the tightness of the pipe connection; measuring the length to ensure accurate installation of the new pipe; and applying glue evenly to make the pipe connection more secure.

In addition, there are some precautions during construction. The pipe joints must be properly sealed to prevent foul odors from escaping and affecting indoor air quality. When cutting slots in the floor, exercise extreme caution to avoid cutting into steel bars, as doing so may turn the floor slab into a dangerous building with serious safety hazards. The waterproofing work must be redone, and a 48-hour closed-water test must be conducted after construction to ensure good waterproofing and prevent leakage problems. For special house types, sunken bathrooms allow for arbitrary relocation of sewage pipes. However, if the pipes are cast iron, they need to be secured with clamps and then sealed with sealant. For bathrooms with same-floor drainage, the decision to relocate sewage pipes can be made independently, while for bathrooms with inter-floor drainage, relocation requires the approval of the property management and signatures from neighbors.