Installation Method for Toilet Mobile Chairs

The installation methods for toilet mobile chairs vary depending on the model. Below are the installation steps for the YC713 and YC7902S models:

Installation Method for YC713 Model:
First, open the packaging and remove all products and accessories, carefully checking that all accessories are present. Next, unfold the main frame, ensuring it is stable, and then secure the parking buckles on both sides. This step ensures that the main frame does not move unexpectedly during installation. When installing the seat plate, pay special attention to aligning the seat plate buckles with the crossbar, and then steadily install the seat plate onto the main frame, ensuring the buckles are secure. After that, proceed with the installation of the footrest support tubes and footrests. Press down on the ball of the footrest support tube and insert it into the footrest. When the ball pops out after insertion, it indicates that the installation is in place, ensuring that the footrest does not loosen during use. Finally, install the toilet bucket by placing it in the appropriate position to complete the entire installation process.

Installation Method for YC7902S Model:
Similarly, start by opening the packaging and removing the product and accessories. First, flip the main frame and install the leg tubes onto it, aligning the holes and securing them with C-shaped buckles. Install the other three leg tubes in the same manner, ensuring that all holes are aligned during installation to guarantee the stability of the chair. Then, insert the backrest into the main frame by aligning the holes and tighten the knob screws to secure the backrest firmly. Lower the armrests on both sides, insert the footrests from the side into the main frame, and then rotate them back to the front. Install the other side in the same way, and then lower the pedals. Next, install the toilet bucket at the rear end. After installation, you can also adjust the height of the leg tubes. First, pull out the C-shaped buckles of the leg tubes, adjust them to the appropriate height, and then insert the C-shaped buckles back into place by aligning the holes. If further adjustment of the backrest angle is needed, loosen the knob screws and nuts, align the holes, and then tighten the knob screws again.