Volver al blog
Artículo

How Long Are the Beams in Prefabricated Houses

Admin 18 de septiembre de 2026

The length of beams in prefabricated houses varies significantly depending on the material and design requirements, and needs to be determined comprehensively in combination with the engineering span, load, and structural type. The following explains from two dimensions: material classification and design requirements.

I. Typical Length Ranges by Material Type

  1. Concrete Prefabricated Beams
    Due to material characteristics, the conventional length of concrete prefabricated beams usually does not exceed 15 meters. This limitation stems from the low tensile strength of concrete: when the beam is too long, it is prone to cracking due to its own weight during transportation and lifting, and temporary supports need to be set up during construction to control deformation. For example, for the concrete roof beams of single-story industrial plants, if the span exceeds 15 meters, it needs to be achieved through prestressed technology or on-site pouring, rather than directly using prefabricated components.

  2. Steel Structure Prefabricated Beams
    Steel structure prefabricated beams, represented by H-shaped steel, have a standard length of 12 meters. Their advantage lies in the ability to be extended to 36 meters through welding processes, but the quality of the welds must be strictly controlled: full-penetration welding, preheating and post-heat treatment processes are required, and ultrasonic flaw detection is used to ensure that the weld grade reaches Class I or Class II standards. For example, the roof beams of large-span stadiums often use welded and extended steel structures to achieve column-free spaces of over 30 meters.

II. Length Ranges Determined by Design Requirements

  1. Single-Span Roof Beams
    The conventional length is 6-24 meters, depending on the building's functional requirements. For example, the roof beam span of residential buildings is usually 6-9 meters to match the standard bay size; while the lobbies or atriums of commercial buildings may adopt spans of 18-24 meters to create open spaces. During design, structural calculations are required to determine parameters such as beam height and reinforcement to ensure that the deformation under load does not exceed L/250 (L is the beam span).

  2. Multi-Span Continuous Beams
    It is recommended that the single span be controlled within 12-18 meters to balance structural efficiency and construction convenience. Multi-span continuous beams can reduce the cross-sectional size of single-span beams through the redistribution of bending moments between adjacent spans, but expansion joints or post-pouring strips need to be set up to cope with temperature stresses. For example, a three-story office building adopts continuous beams with a span of 15 meters and sets up a post-pouring strip every 30 meters to effectively control concrete shrinkage cracks.

III. Key Influencing Factors

  1. Load Conditions: The combined values of live loads (such as personnel and equipment) and dead loads (such as self-weight and decoration) directly affect the cross-sectional size and maximum length of the beams. For example, the beam span of heavy industrial plants usually does not exceed 12 meters to avoid excessive deflection affecting equipment operation.
  2. Structural Type: In frame structures, the rigid connection between beams and columns requires that the beam length matches the column spacing; while in portal frame structures, beams can be set up independently, with greater flexibility in length.
  3. Construction Conditions: Practical factors such as the height limit of transportation roads and the on-site lifting capacity (such as the maximum lifting capacity of tower cranes) may limit the maximum length of prefabricated beams. For example, in a mountainous project, due to the narrow transportation roads, the originally designed 18-meter concrete beams were split into two 9-meter prefabricated sections and then spliced on site.