Mobile Toilet Installation Guide

The installation steps for mobile toilets are mainly divided into two types: basic installation and simple installation. The specific operations are as follows:

I. Basic Installation Steps (Applicable to factory-prefabricated finished products that require on-site assembly)

1. Tool Preparation
   After receiving the goods, prepare tools such as an electric drill, a 4.2-millimeter drill bit, and a rivet gun in advance. These tools are used to secure structural components and ensure installation stability.

2. Corner Installation
   First, install the corner components sequentially at the designated positions. The corners are key structures that support the frame and must be aligned according to the design drawings or instructions to ensure the accuracy of subsequent assembly.

3. Panel Assembly and Fixation
   Insert the prefabricated panels into the slots, aligning the top and bottom edges as well as the side interfaces. Use an electric drill to make holes at the assembly points (the hole diameter must match the rivets), insert the rivets, and secure them with a rivet gun. This step requires careful inspection to ensure the panels are level and vertical, preventing structural looseness due to installation deviations.

4. Functional Component Debugging
   After completing the main structure, connect the water and electricity pipes (if equipped with a flushing system) and test whether functions such as sewage discharge and ventilation are normal. Some mobile toilets require the installation of odor-proof floor drains or sealing strips, which should be done according to the instructions.

II. Simple Installation Steps (Applicable to small mobile toilets or modular products)

1. Unpacking Inspection
   After opening the package, check the accessory list (such as brackets, toilet seats, sewage pipes, etc.) to ensure nothing is missing or damaged. If any parts are found to be defective, contact the supplier promptly for replacement.

2. Bracket Assembly
   Assemble the bracket parts according to the instructions, usually using snaps or screws for fixation. Ensure the load-bearing design of the bracket matches the usage scenario (e.g., outdoor use requires enhanced stability).

3. Toilet Seat and Water Tank Installation
   Secure the toilet seat onto the bracket and connect the water tank to the inlet valve (if it is an electric flush, connect to the power supply). Some products require pre-installed batteries or connection to an external power source, strictly following voltage requirements.

4. Sewage Pipe Connection
   Connect the sewage pipe to the toilet outlet and the septic tank (or municipal sewage outlet), using sealing rings or tape to prevent leakage. For waterless flushing types, install collection bags or biodegradable devices.

Precautions:

• Mobile toilets are mostly factory-prefabricated, so confirm the ground levelness before on-site installation to avoid structural deformation due to uneven foundations.
• Wear protective gloves during installation to prevent cuts from rivets or tools.
• If water and electricity modifications are involved, it is recommended to have them done by professionals to ensure compliance with safety regulations.
• After installation, conduct functional tests, including flushing, sewage discharge, and ventilation, to ensure everything is normal before putting the toilet into use.