How to Remove Mobile Door Toilet Partitions

The removal of mobile door toilet partitions requires selecting the appropriate method based on the specific type, with core steps including disassembling connectors, separating panels, and cleaning and maintaining. Safety precautions and preservation of accessories should be noted during operation.

I. Select Removal Methods Based on Partition Type

1. Movable Partitions

   • Steps:
     • First, remove the top hooks and guide rails, and use a screwdriver or power tool to remove the fixing screws.
     • Remove the partition panels one by one, ensuring two people cooperate to maintain panel balance and prevent damage from tilting or swinging.
     • Clean the panel and rail surfaces, remove dust or residual adhesive, and check for rail deformation.
   • Key Points: Hooks and guide rails are the core connectors of movable partitions and should be removed first; panels should be stored flat or vertically after removal to prevent deformation.

2. Foldable Partitions

   • Steps:
     • Identify the folding connections (usually hinge or snap-fit structures), and use a screwdriver or wrench to loosen the fixing screws or snaps.
     • Remove the folding panels one by one, marking the panel order for subsequent installation or storage.
     • Clean the partition panels, systems, and accessories (such as hinges and pulleys), and check for wear or rust.
   • Key Points: The connectors of foldable partitions are relatively precise, so avoid excessive force during removal to prevent breakage; accessories should be stored separately to prevent loss.

II. General Removal Steps (Applicable to Most Toilet Partitions)

1. Turn Off Water and Electricity Facilities:
   • Before removal, turn off the main power and water valve in the toilet to prevent electric shock or water leakage risks.
2. Remove Rails and Fixing Screws:
   • Use a drawer rail remover or electric screwdriver to remove the fixing screws of the partition rails at the top and bottom.
   • Remove the screws connecting the partition to the wall (usually located on the sides or corners).
3. Separate Panels from the Floor:
   • Remove the screws connecting the partition bottom to the floor, and loosen the bottom hooks or snap-fit structures.
   • Two people should cooperate to lift the partition and slowly move it out of the installation position to avoid scratching the floor.
4. Handle Wall Adhesive Materials:
   • Use a wallpaper knife to carefully cut the adhesive material (such as glass glue or foam glue) between the wall and the partition panel.
   • If the adhesion is strong, use tools such as a hammer or axe to assist in removal, but control the force to avoid damaging the wall.

III. Precautions

• Safety Precautions: Wear gloves and goggles to prevent injury from screws or debris.
• Preservation of Accessories: Retain as many accessories as possible, such as hooks, transmission mechanisms, and screws, and label their uses for subsequent maintenance or reinstallation.
• Wall Protection: Avoid using sharp tools to directly pry the wall during removal to prevent scratches or holes.
• Rail Maintenance: Thoroughly clean dust and debris from the rails, check for deformation or jamming, and apply lubricant if necessary.