How to Operate a Smart Mobile Toilet

The operation method of a smart toilet mainly includes steps such as power-on and preheating, cleaning, drying, flushing, and adjustment of other functions, as detailed below:

1. Power-on and Preheating
Open the dedicated angle valve to allow water to flow into the pipes, plug in the leakage protection plug, and the red light indicates startup. After the power indicator light on the display screen lights up, the real-time settings for water temperature, seat temperature, and air temperature are displayed. For most smart toilets, the seat automatically enters standby mode when powered on. If seat heating is supported, the temperature setting can be adjusted in advance via the remote control or side panel (usually 4 settings, including room temperature without heating, and 34℃, 37℃, and 40℃).

2. Cleaning Function

• Basic Modes: After seat sensing is activated, rotating the side knob forward initiates feminine wash (blue indicator light), and repeated rotation allows for forward and backward movement during cleaning; rotating it backward initiates posterior wash (green indicator light), with similar range adjustment. Alternatively, the “posterior wash” or “feminine wash” buttons on the remote control can be used to start the function, and the spray rod automatically cleans itself when extending. The feminine wash has a gentler water flow and is positioned more forward, suitable for women during menstruation or postpartum care; the posterior wash targets the rear area for daily cleaning.
• Function Adjustment: Use the “position+”/“position-” buttons on the remote control to adjust the cleaning position (6 settings in total); repeatedly press the “posterior wash” or “feminine wash” buttons to move the spray rod forward and backward; press the “water pressure+”/“water pressure-” buttons to adjust the pressure (3 settings in total); press the “massage” button to activate a massage mode with alternating strong and weak water pressure. The cleaning time is generally 30 seconds to 1 minute. After cleaning, press the “stop” button, and the spray head retracts and cleans itself.

3. Drying Function
After cleaning, click the side knob to start drying (red indicator light), and click again to stop; or use the “warm air” button on the remote control to start it. The air temperature can be adjusted in 4 settings (including room temperature without heating, and 44℃, 50℃, and 56℃). It is recommended to start with a low temperature for trial use.

4. Flushing Operation

• Manual Flushing: When not seated, long-press the side knob to turn the toilet on or off, and short-press to flush; during a power outage, short-press for emergency flushing; the flushing can also be done using the remote control or the manual button on the side of the toilet.
• Automatic Flushing: Long-press the “flush setting” button on the remote control to enable automatic flushing when leaving the seat, and the sensor triggers flushing upon standing up.
• Foot-sensing Flushing: For men urinating, extending the foot to the front of the foot-sensing sensor (distance < 13 cm) initiates flushing.

5. Other Functions

• Pairing Function: Rotate the side knob towards the posterior wash direction for 5 seconds until a beep is heard to enter pairing mode, and press any button on the remote control to complete pairing.
• Night Light Function: Press the “night light” button on the remote control to turn it on or off.
• Temperature Adjustment: The water temperature, seat temperature, and air temperature can all be adjusted via corresponding buttons to meet personalized needs.