Volver al blog
Artículo

How to Fix Prefabricated Concrete Houses

Admin 18 de septiembre de 2026

The fixation of prefabricated concrete houses requires selecting appropriate methods based on structural characteristics. Common methods are as follows:

I. Structural Reinforcement Methods

  1. I-beam Reinforcement
    Suitable for old rural prefabricated panel houses, this method involves placing horizontal I-beams in a cross shape with the prefabricated panels to enhance the overall stiffness of the floor. Vertical I-beam columns need to be erected at both ends, with their bases fixed to the foundation wall using expansion bolts or welding, forming a frame structure. This method can significantly improve the bending resistance of the floor, especially suitable for single-story or low-rise house renovations.

  2. Adding a Concrete Layer to Prefabricated Panels
    Pour a concrete layer (recommended thickness ≥ 5 cm) on the surface of the existing prefabricated panels. A local hole needs to be made through one panel to form a beam, and a vertical cross beam is added on the beam. Connect the old and new structures through steel bar binding to form an integrated load-bearing system between the beams and the floor. This method can increase the load-bearing capacity of the floor, but attention should be paid to the concrete curing period and the bonding quality with the original structure.

II. Direct Fixation Methods

  1. Nail Fixation Technique

    • Tools and Materials: Use an impact drill (equipped with a 6-8 mm alloy drill bit) to drill holes. Self-tapping screws should be ≥ 50 mm in length and ≥ 4 mm in diameter to ensure penetration through the concrete layer and anchoring into the internal steel reinforcement mesh.
    • Operation Points:
      • When positioning, avoid embedded pipelines (keep a distance of ≥ 10 cm from the panel edge), and control the nail spacing in load-bearing areas to 30-40 cm;
      • Drill holes perpendicular to the panel surface, with a depth 1-2 cm shorter than the screw length. Adjust the position if encountering steel bars;
      • Inject epoxy resin anchoring agent into the holes, then use an electric screwdriver to screw in the screws with a torque of 4-6 N·m to ensure anchoring force.
  2. Seam Reinforcement
    For multi-story panel houses, use L-shaped angle brackets (thickness ≥ 3 mm) with stainless steel expansion screws for fixation. Drill three staggered screws on each side of the seam to form a triangular load-bearing structure and prevent seam cracking. Apply structural adhesive on the contact surface between the angle brackets and the prefabricated panels to enhance bonding.

III. Environmental Adaptability Reinforcement

  1. Response to Extreme Climates

    • For wind-resistant houses, increase the nail point density by 30%, focusing on reinforcing areas prone to wind pressure such as door and window openings and eaves;
    • In permafrost regions, use hot-dip galvanized screws to prevent metal embrittlement caused by low temperatures, and ensure the foundation burial depth exceeds the permafrost layer.
  2. Seismic Reinforcement
    Add reinforced concrete structural columns at the ends of the prefabricated panels and connect them to the panels using rebar planting technology to form a continuous load-bearing system. The recommended cross-sectional dimensions of the structural columns are ≥ 240 mm × 240 mm, and the rebar ratio should comply with local seismic design codes.

Precautions: Before any fixation operation, detect the distribution of steel reinforcement inside the prefabricated panels (using a steel reinforcement scanner) to avoid damaging the main reinforcement of the structure. The reinforcement plan should be checked by a structural engineer to ensure compliance with the requirements of the "Concrete Structure Design Code".