C50 Prefabricated Housing
C50 prefabricated housing mainly involves two major aspects: cement prefabricated panel houses and prefabricated beam construction for buildings, with specific applications as follows:

Cement Prefabricated Panel Houses:
C50 concrete is commonly used in the mix ratio for prefabricated panels (ranging from C30 to C50), with bidirectional steel reinforcement mesh incorporated internally to enhance structural strength. Based on functional requirements, prefabricated panels are categorized into three types:
- Hollow Floor Panels: Lightweight and suitable for non-load-bearing partition walls, reducing material usage through internal hollow structures.
- Solid Large Panels: With a compressive strength exceeding 30MPa, they are primarily used for load-bearing walls, meeting the demands of high-rise or large-span buildings.
- Sandwich Insulation Panels: Filled with EPS/XPS insulation materials in the middle, their thermal conductivity can be reduced to 0.5W/(m·K), significantly improving energy efficiency and suitable for cold regions.
Construction requires strict control of indicators: installation gaps should be controlled within 5-8mm and filled with elastic grout; panel connections should use embedded parts for welding (with weld lengths ≥10cm); and foundation flatness deviations should be <3mm/m. These panels have a wide range of applications, including temporary housing on construction sites (with a lifespan of 3-5 years), new rural construction (with a designed lifespan of 50 years), and emergency relief housing (for rapid deployment within 72 hours). In regions with frequent freeze-thaw cycles (such as Northeast and Northwest China), panels with a frost resistance grade of F50 or higher should be selected, and chloride ion penetration should be tested annually (recommended ≤0.06%).
Prefabricated Beam Construction for Buildings:
C50 concrete achieves a 28-day compressive strength of ≥55MPa and an elastic modulus of 3.5×10⁴MPa through optimized mix design (incorporating high-efficiency water reducers and fly ash), meeting high load-bearing requirements. The construction of a prefabricated beam yard requires selecting a flat and easily accessible location. The site should be hardened with 20cm-thick C20 concrete, with a 5‰ drainage slope set up. It should be divided into five functional areas (raw material storage, steel reinforcement processing, formwork storage, prefabrication, and beam storage), each separated by 1.8m-high colored steel plates. The foundation of the prefabrication area pedestals should use 30cm-thick C30 concrete with Φ12 steel reinforcement mesh. The pedestal surface should be paved with 6mm-thick steel plates and polished flat, with 50×50mm angle steels installed on both sides for positioning the side formwork. The beam storage area should adopt a double-layer storage method, with pedestal bearing capacity not less than 1500kN.
Construction machinery includes formwork systems, lifting equipment, concrete equipment, etc. Materials must be strictly inspected: main materials such as cement and steel reinforcement should be accompanied by factory certificates and pass experimental sampling inspections before use.




