Toilet Wall Relocation

Toilet wall relocation can be carried out if the wall is non-load-bearing, but key issues such as waterproofing, plumbing and electrical work, and wall materials must be considered.

Waterproofing is crucial: When removing the original wall and rebuilding a new one, a cement waterstop strip must be poured first, with a minimum height of 15 - 20 centimeters, to block the path of groundwater penetration. The waterproofing on the bathroom interior walls should be applied up to a height of 180 centimeters and tiled. If the new wall is adjacent to a storage room, the storage room wall should also be waterproofed simultaneously to prevent moisture from spreading to other spaces through the wall.

Plumbing and electrical routing need to be planned in advance: Before removing the partition wall, the locations of the plumbing and electrical lines within the original wall must be confirmed to avoid damaging them during construction. If a bathtub and toilet are planned to be installed next to the newly built wall, the toilet drain pipe needs to be relocated. During relocation, the ground slope must be strictly leveled to ensure the correct drainage direction and prevent water accumulation or odors on the floor later. After the plumbing and electrical renovations are completed, pressure tests and closed-water tests should be conducted to verify the tightness of the lines and the waterproofing effectiveness.

The choice of wall materials affects structural safety: It is recommended to use lightweight bricks (such as aerated concrete bricks) for the newly built wall. Their weight is only one-third of that of ordinary bricks, which can reduce the load pressure on the cast-in-place ground beam and minimize the risk of wall subsidence. If space permits, a cast-in-place ground beam (with a height of about 15 - 20 centimeters) can be poured at the bottom of the lightweight brick wall to further enhance the wall's stability and prevent cracking due to ground settlement.

Construction details must be strictly controlled: During wall construction, ensure that the brick joints are full and use special waterproof mortar for jointing. Steel wire mesh should be hung at the junction of the new wall and the original wall to prevent cracking due to different material shrinkage rates. The ground leveling layer should have a reserved drainage slope (usually 2% - 3%) to ensure that water flows towards the floor drain. After construction is completed, wait for more than 28 days (the full curing period of the cement) before proceeding with subsequent renovations to avoid problems such as hollow tiles or tile detachment due to an unstable wall.