Toilet Mobile Chair Installation Tutorial

The installation tutorials for different models of toilet mobile chairs are as follows:

YC7902S Commode Chair

1. Basic Installation: Open the packaging, take out the product and accessories. Flip the main frame, install the foot tubes onto the main frame, align the holes, and secure them with C-shaped clips. Install the remaining three foot tubes in the same manner, ensuring all holes are aligned. Insert the backrest into the main frame, aligning the holes, and tighten the knob screws to secure it. Lower the armrests on both sides, insert the footrests from the sides into the main frame, rotate them to the front, and repeat the operation on the other side before lowering the footrests. Finally, install the commode bucket at the rear end to complete the basic installation.
2. Height Adjustment: Pull out the C-shaped clips of the foot tubes, adjust the foot tubes to the desired height, align the holes, and reinsert the C-shaped clips to secure them. To adjust the backrest angle, loosen the knob screws and nuts, align the holes, and retighten the knob screws.
3. Usage Precautions: Before entering the commode chair, secure the wheel brakes. Avoid stepping on the footrests when leaving to prevent tipping forward. When pushing the chair, release the brakes first. However, due to the small wheels, avoid pushing it over bumps or uneven surfaces.

YC749 Commode Chair

1. Main Assembly: After opening the packaging, take out all accessories, unfold the main frame, fold the armrests inward, and unfold the seat upward. Align the holes and press the ball catches to insert them. Wait for the ball catches to pop out to complete the fixation, and repeat the operation on the other side.
2. Foot Tube and Commode Bucket Installation: Install the foot tubes onto the main frame, press the ball catches to insert them, and ensure all foot tube positions are consistent. Place the commode bucket into the commode chair, aligning it with the slide rails to prevent sliding.
3. Backrest Installation: Place the washer into the knob screw, insert the backrest into the main frame, aligning the holes, and tighten the knob screw to complete the fixation.
4. Adjustment Functions: Press the ball catches to adjust the height of the foot tubes or the angle of the backrest upward or downward as needed.

Ordinary Folding Commode Chair

1. Initial Assembly: Assemble the main body of the stool by inserting the two legs into the corresponding holes.
2. Position Adjustment: After estimating the position, if the leg position is too far back, adjust the screw rod forward to the appropriate hole position. After adjustment, test the position again to ensure comfort.
3. Screw Fixation: Tighten the screws after the position is appropriate. If the screws are not tightened, the stool will not fold properly, affecting safety during use.