Installation of Mobile Toilet with Flushing System

There are mainly two ways to install a mobile toilet with a flushing system, as follows:

Installation of a Simple Mobile Toilet

The installation of this type of mobile toilet is relatively simple and consists of six steps. First, upon receiving the product package, open it immediately and carefully check whether all the accessories inside are complete. This is an important preparatory step before installation. If any accessories are found to be missing, contact the merchant promptly for a replacement to avoid affecting the subsequent installation process. After checking and confirming that everything is in order, you can start the formal installation. Since the installation steps for this type of toilet are relatively few and the operation difficulty is low, you can refer to the detailed instruction manual that comes with the product for the specific installation method and complete the installation step by step according to the instructions.

Installation of a Dual-Purpose Mobile Toilet (Squat and Sit)

1. Install the toilet flange: Place the toilet flange in the appropriate position, ensuring that the center of the flange is precisely aligned with the center of the sewer pipe, and then place the toilet upright. This step is very crucial. If the flange is not aligned with the center of the sewer pipe, it may cause the toilet to be installed unstably and lead to problems such as water leakage during later use.
2. Install the angle valve and connecting components: Install the angle valve and connect the three-way joint for the water inlet and the sprinkler head. The angle valve serves to control the water flow, and proper installation ensures the normal water supply of the toilet. When connecting the three-way joint, ensure that the interfaces are tight to prevent water leakage.
3. Screw on the toilet water inlet hose: Screw the toilet water inlet hose onto the corresponding interface, making sure to tighten it to avoid the hose coming off and causing water leakage during use.
4. Assemble the toilet sprinkler head: Assemble the toilet sprinkler head, paying special attention to tightening the sealing rubber rings at both ends. The function of the sealing rubber rings is to prevent water leakage. If they are not tightened properly, water will leak from the connection of the sprinkler head. After assembly, connect the sprinkler head to the other end of the three-way joint.
5. Install the sprinkler head bracket: Forcefully snap the sprinkler head bracket onto the top of the three-way joint, ensuring that the bracket is installed firmly and can stably support the sprinkler head.
6. Water test and caulking: After completing the above installation steps, conduct a water test on the toilet to check for any water leakage at the connection points. If there are no problems with the water test, you can proceed with the caulking operation. Caulking can further enhance the sealing between the toilet and the floor, preventing odor emission and water leakage.