Mobile Toilet Simple Bathroom

There are various ways to make a mobile toilet simple bathroom, with two common methods being the use of a water storage tank and a pallet, and the use of a water storage bucket.

Construction Using a Water Storage Tank and Pallet

1. Basic Frame Construction: Fix universal wheels at the four corners of the pallet bottom for easy overall movement. Place the water storage tank retrieved from a garbage station and use an angle grinder to cut along the top marking line to form an open-top tank. Invert and stack two open-top water storage tanks and secure them with self-tapping screws to construct the main frame of the simple bathroom.
2. Opening and Internal Facility Installation: Cut a rectangular opening to form a doorway for easy personnel access. Drill holes in the interior floor, insert elbows and water pipes, and seal them. Install and secure the toilet. Fix water pipes on the wall with clips, install a faucet, connect a pipe cap below, drill a hole as a drain pipe outlet, and secure a stainless steel basin as a sink on the pipe cap.
3. Completion of Other Facilities: Connect the toilet tank inlet pipe and shower hose, install the toilet seat and a showerhead made from a water pipe. Finally, make a bathroom door using wooden boards and hinges and install a door handle. This completes the basic construction of a simple mobile bathroom.

Construction Using a Water Storage Bucket

1. Main Body Modification: Use an angle grinder to split the water storage bucket in half. Fix universal wheels at the four corners of a wooden board. Secure wooden strips to the upper side of the bucket with self-tapping screws to increase height. Cut an opening on the side of the bucket, install sponge strips on both sides of the doorway to form a door frame, insert plastic soft boards between the wooden strips to form an elevated wall, and place the upper half of the bucket on top of the wooden strips to form a roof.
2. Waterproofing and Door Construction: Apply white waterproof paint to the wooden strips to prevent moisture damage. Make a simple door using foam strips and discarded honeycomb wooden boards.
3. Drainage and Water Facility Installation: Drill a hole at the bottom of the bucket and install a drain pipe to form a floor drain. Drill holes on the side and bottom of the plastic bucket and install direct connectors. Place the plastic bucket on the roof to form a small water storage device. Connect a water pipe-made bathroom heater, install a three-way connector below the inlet pipe and connect a showerhead, place and install a toilet tank, secure the toilet with glass glue, connect the drain pipe to a sewage bucket, horizontally connect a water pipe from the outlet pipe three-way connector to the doorway as a sink inlet pipe and install relevant connectors and hoses, and drill a hole in the door to install a connector.