How to Use Mobile Toilet Dissolving Agent

The usage method of mobile toilet dissolving agents should be adjusted according to the product form (solid or liquid), with specific steps as follows:

I. Pre-treatment and Safety Protection

1. Ventilation and Protection: Ensure good ventilation in the restroom before use to avoid inhaling volatile gases; wear rubber gloves to prevent direct skin contact (some products contain strong acids or alkalis).
2. Removal of Surface Contaminants:
   • For mobile toilets, first remove floating debris from the water surface and keep the water level lower than usual.
   • Rinse the inner walls of the toilet with clean water to remove loose urine scale or debris, providing a clean contact surface for the dissolving agent.

II. Product Preparation and Application

1. Solid Powder Dissolving Agent:

   • Dosage: Take 20-30g of powder (adjust according to the degree of staining) and evenly sprinkle it on the inner walls of the toilet or where urine scale has accumulated.
   • Standing Time: For ordinary stains, let it stand for 15-30 minutes; for stubborn stains, extend to 1 hour, but no more than 2 hours per application.
   • Special Operation: Before going to bed, scoop out some of the toilet water to ensure the water can submerge the urine scale, pour the powder into the pit, and utilize the long standing time overnight to enhance the effect.
   • Note: Avoid excessive use to prevent powder buildup from clogging the drain.

2. Liquid Dissolving Agent:

   • Operation Method: Spray directly or pour slowly into the toilet, covering the stained area, and pour along the inner walls to reduce splashing.
   • Standing Time: 10-20 minutes to ensure the dissolving agent fully penetrates and decomposes the dirt.

III. Scrubbing and Rinsing

1. Scrubbing: Use a toilet brush to thoroughly clean the inner walls, paying special attention to areas prone to residue such as the edge grooves.
2. Rinsing: Rinse with a large amount of clean water to remove any remaining dissolving agent, avoiding corrosion of the ceramic or pipes; avoid frequent flushing within 12 hours after use, and use no more than once a week.

IV. Handling Special Situations

1. Stubborn Urine Scale: Repeat the operation or extend the standing time, but no more than 2 hours per application.
2. Pipe Unblocking: If urine scale clogs the drain, after confirming the product is suitable, pour the dissolving agent into the pipe opening or the toilet drain (preferably the drain for targeted and safer application), and flush after standing.

Precautions

• Prohibited Mixing: Do not mix with other cleaning agents such as bleach, as toxic gases may be produced.
• Safety Isolation: Ensure children and pets are kept away from the area during operation.
• Storage Conditions: Store solid products in a dry and cool place, avoiding moisture; keep liquid products away from direct sunlight.