How to Remove Mobile Toilet Door Partitions

The removal of mobile toilet door partitions requires selecting the appropriate method based on the type (sliding door or fixed type), and strict adherence to safety regulations during operation to avoid damaging walls or pipelines.

I. Steps for Removing Sliding Door Partitions

1. Remove the Track
   • Use a screwdriver or wrench to unscrew the screws (usually 2-4) securing the track on both sides of the wall. Avoid applying excessive force to prevent wall peeling.
   • Place the track properly to prevent deformation that may affect subsequent use.
2. Separate the Door Panel from the Track
   • Locate the adjustment screw beneath the door panel and rotate it counterclockwise to detach the bottom of the door panel from the track, ensuring complete separation.
   • Gently lift the door panel while pulling it out from the drive mechanism, maintaining a steady motion to prevent damage from falling.
3. Remove the Door Frame
   • Unscrew the fixing screws on both sides of the door frame. If there are additional fixing devices (such as clips), handle them according to the actual situation.
   • Use a rubber mallet to gently tap both sides of the door frame to separate it completely from the wall, avoiding direct impact that may cause wall indentation.

II. Steps for Removing Fixed Partitions

1. Prepare Tools and Protective Gear
   • Tools: Electric screwdriver, axe, hammer, drawer track remover, wallpaper knife, hand drill, etc.
   • Protective Gear: Safety helmet, gloves, goggles, mask to prevent injury from flying debris or dust during removal.
2. Remove Connecting Components
   • Use a drawer track remover to detach the tracks at the top and bottom of the partition. If the tracks are tightly bonded to the wall, use a wallpaper knife to assist in cutting.
   • Use an electric screwdriver to remove the connecting screws between the partition and the wall and floor, noting to save the screws for subsequent installation.
   • Loosen the hooks at the bottom of the partition from the floor. Two people should collaborate when lifting the partition to prevent tipping.
3. Remove Partition Panels
   • Use a wallpaper knife to cut through the adhesive material (such as glass glue) on the wall. If the partition panel is wooden, use an electric drill to assist in removal.
   • Use a hammer, axe, or other tools to dismantle the partition panel. If there are internal supports (such as wooden boards), use a hammer to break them and remove them.

III. General Precautions

1. Safety Protection
   • Turn off water and electricity facilities before removal to avoid electric shock or water pipe rupture.
   • Maintain stability during operation to avoid cutting or collision. If wires or water pipes are embedded in the partition, pause removal and contact professionals for handling.
2. Wall Protection
   • Be cautious when removing partition panels to prevent scratching or damaging the bathroom wall. Pay attention to the force when unscrewing to avoid screw slippage.
3. Cleaning and Waste Disposal
   • After removal, clean up residues (such as glue, screws) on the floor and wall. Waste should be sorted for disposal (recyclable materials should be stored separately).

IV. Handling Special Situations

• Complex Structures: If the partition has additional fixing devices (such as expansion screws) or support structures, adjust tools and steps according to the actual situation. Use an angle grinder for cutting if necessary.
• Pipeline Interference: Before removal, use a detector to check if there are pipelines embedded in the partition. If found, mark the location and contact a plumber for handling.