How to Install a Squat Toilet in a Mobile Toilet

The method of installing a squat toilet in a mobile toilet varies depending on the type. Here are the specific installation methods for different types of mobile toilets:

Stainless Steel Waterless Packaging Squat Toilet

• Floor-standing Bracket Model: Installation is relatively simple. First, place the floor-standing bracket in the appropriate position according to the design requirements and secure it well to ensure the bracket is stable and firm. Then, place the stainless steel waterless packaging squat toilet on the bracket, adjust its position to make it level, and ensure comfort and stability during use.
• Underground Installation Model: First, perform waterproofing treatment, which is a very crucial step to effectively prevent leakage problems during subsequent use. The ground must be leveled to provide a flat surface for the installation of the squat toilet. Next, fix the steel frame and add rubber pads at the contact points between the steel frame and the ground to provide cushioning and sealing. Then, place the squat toilet on the steel frame and carefully adjust it to ensure it is level. Note that the stainless steel shell should not be directly in contact with cement to avoid damage to the shell.

Direct-discharge Squat Toilet Mobile Toilet

The installation process is relatively complex. First, evenly apply structural adhesive to the tee joint and then install it to ensure a firm connection. Use a rivet gun and an electric drill to fix the corner posts to the panels, constructing the basic framework of the toilet. Then, install the wall panels, door panels, louvers, and other components in sequence, ensuring accurate and firm installation of each component. When installing the sewage discharge pipes, pay attention to the slope and connection sealing of the pipes to ensure smooth discharge of sewage. Install equipment such as flush tanks, washbasins, faucets, exhaust fans, and light bulbs, and connect the corresponding water and electricity lines. Finally, check and fix the connections of each component, carefully inspect each connection point to ensure there are no water leaks, electric shocks, or other safety hazards.

Ordinary Squat Toilet

Based on the product's sewage outlet, reserve a sewage pipe at an appropriate distance from the wall and determine the distance from the entrance of the sewage pipe to the ground level. Reserve a recess in the ground for installing the squat toilet, with a depth greater than the height of the toilet. Insert the connecting rubber plug into the water inlet hole of the squat toilet and tighten it. Apply glass glue or putty to the outer edge in contact with the water inlet hole, insert the water inlet pipe, and ensure a good seal. Apply glass glue or putty to the edge of the water outlet hole of the squat toilet, insert it into the entrance of the sewage pipe, and rotate it to fit. Use fillers to level it. Open the water inlet system to check for leaks at each joint. After resolving any leakage issues, fill the area around the toilet with fillers, use elastic materials at the contact surface between the ceramic and the cement mortar, fix the squat toilet with cement mortar, lay bathroom floor tiles, and test the flush. If there are no abnormalities, it can be used.