How to Fix the Bottom of a Mobile Toilet

The method for fixing the bottom of a mobile toilet should be selected based on the specific scenario and requirements. Common fixing methods are as follows:

Municipal Rental Scenario:

1. Ground Preparation: Choose a flat surface and use a level to confirm that the installation area is level, avoiding equipment instability due to ground inclination.
2. Shock-Absorbing Base Installation: Place the shock-absorbing base bracket steadily and adjust the height of the four corners to ensure the equipment is level. When using expansion bolts for fixation, select the bolt length according to the ground material: long bolts for concrete floors and compact the soil for earth floors to ensure uniform tightening of the bolts.
3. Shock-Absorbing Component Installation: When installing shock-absorbing rubber pads or spring shock absorbers, ensure they are fully in contact with the bracket and ground without misalignment or suspension. After installation, gently push the equipment to test the shock-absorbing effect. If abnormal shaking occurs, check whether the rubber pad is worn or if the shock absorber is installed in the wrong direction.
4. Final Inspection: Use a level to recheck the overall levelness, inspect the firmness of all connections, ensure the anchor bolts are tightened properly, and perform a simple shaking test to confirm the shock-absorbing effect. If possible, observe the equipment stability within 24 hours after installation.

Yingtan Rental Scenario:

1. Site Selection Requirements: Prioritize placing the equipment on flat terrain, avoiding low-lying areas prone to water accumulation or areas directly exposed to strong winds.
2. Fixing Method: After positioning the equipment, use professional ground anchors for fixation and enhance bottom stability with expansion screws or weighted sandbags. It is recommended to equip each unit with 4 fixing points to ensure even distribution.

Guilin Transportation Scenario:

1. Small Mobile Toilets: Select high-strength nylon straps with a width of over 5 cm and a tensile strength of no less than 5000 kg. Wrap the straps around the bottom or side fixing points and tie them to the fixing rings or rails of the transport vehicle, ensuring they are tight and free from looseness.
2. Large or Heavy Mobile Toilets: Use steel wire ropes with a diameter of no less than 8 mm, paired with professional steel wire rope clamps for fixation. Use at least 3 clamps per fixing point, with a spacing between clamps of no less than 6 times the diameter of the steel wire rope.
3. Fixing Position: Connect the straps, chains, or steel wire ropes at the specially designed fixing points or reinforced structures at the bottom corners or edges, and tighten them through the fixing rings or brackets at the bottom of the vehicle to ensure the bottom is closely attached to the carriage.
4. Side Auxiliary Fixing: For taller or easily摇晃 (shaky, here it means unstable) equipment,斜拉 (diagonally pull) straps or steel wire ropes from the side middle or upper fixing points (such as handles or rails) to the side rails or columns of the vehicle, forming a triangular stable structure.
5. Protective Measures: Place 5 cm thick, rough-surfaced anti-slip rubber pads at the contact areas between the equipment and the carriage to increase friction. Place foam boards, sponges, or other cushioning materials around and at the contact areas of the fixing points to reduce collisions and friction.