How to Disassemble the Base of a Mobile Toilet

The method for disassembling the base of a mobile toilet depends on the fixing method. Here are common scenarios and operational steps:

If the base is fixed with structural adhesive

1. Soften the adhesive: Use a hairdryer (or heat gun) set to a medium-low temperature (about 60-80℃) and continuously blow along the edge of the base for 3-5 minutes, focusing on heating the seams to soften the adhesive.
2. Cut the gap: Insert a utility knife into the gap between the base and the ground to a depth of about 1-2 centimeters. Then, insert a plastic sheet (such as a hard card) or a specialized scraper and slowly slide it to widen the gap. During this process, you can use a rubber mallet to gently tap the side wall of the base to assist in loosening it.
3. Clean up residues: After disassembly, soak the cured adhesive on the ground with alcohol, turpentine, or a specialized adhesive remover. Once the adhesive has softened, remove it with a scraper. If the base is made of ceramic, sand the remaining adhesive flat.
   Precautions: Wear gloves during operation to avoid burns from high temperatures or cuts from the knife. If the adhesive has cured for a long time, extend the heating time to 5-8 minutes.

If the base is fixed with screws

1. Locate the screws: Check the underside, sides, or hidden positions inside the base to find the fixing screws (usually cross-head screws).
2. Loosen the screws: Use a cross-head screwdriver of the corresponding size and turn it to the right to loosen the screws. If the screws are rusty, spray a small amount of lubricant (such as WD-40) to assist in disassembly.
3. Separate the components: After removing the screws, if the base is equipped with fixing plates or plastic card holders, remove them as well. If the base still cannot be separated, use a specialized base disassembly tool to fix the base and then unscrew the remaining screws.
   Precautions: Turn off the water supply before disassembly (if water pipes are connected) to avoid leaks. Store the screws separately to prevent loss.

If it is a common toilet-style base disassembly

1. Loosen the fixing screws: Use a cross-head screwdriver to loosen the fixing screws on both sides of the base (usually located under the cover plate).
2. Remove the cover plate and base: Pull the cover plate backward as a whole and then remove the fixed base. If the base is adhered to the ground, gently shake the base to assist in separation.
   Precautions: Keep the base balanced during operation to avoid damage from excessive force. If the screws are stripped, use pliers to clamp the head of the screw and rotate it to remove it.