Back to blog
Article

Thickness of Prefabricated Walls in Heavy Steel Houses

Admin September 18, 2026

The thickness of prefabricated walls in heavy steel houses typically ranges from 150 to 250 mm, with specific values determined based on regulations and engineering requirements. The following provides an in-depth explanation from three perspectives: design benchmarks, regulatory requirements, and practical engineering applications.

I. Design Benchmark Range and Basis

The standard thickness design benchmark for prefabricated concrete walls in heavy steel villas is 150-250 mm. This range has been validated through structural mechanics calculations and engineering practices, meeting the vertical load transfer requirements of most residential buildings while considering lightweight construction needs. Specifically, 150 mm is the minimum thickness, primarily based on two considerations: ensuring effective coverage of internal reinforcement by the concrete protective layer to prevent corrosion and meeting the strength requirements of the foundation structure to avoid insufficient load-bearing capacity due to overly thin walls. 250 mm is the maximum thickness, typically used for strengthening special load-bearing nodes (such as walls around staircases and elevator shafts) by increasing the cross-sectional size to enhance local shear and bending resistance.

II. Regulatory Requirements for Steel Structure Buildings

According to the General Code for Civil Buildings, the thickness standard for steel-concrete prefabricated panel exterior walls in steel structure buildings is 180-200 mm. This regulation applies to building types with steel structures as the framework and prefabricated panels as the enclosure system, with the thickness range considering factors such as thermal performance (e.g., thermal insulation), fire performance (e.g., fire resistance limits), and construction convenience. For example, a thickness of 180 mm can meet the energy-saving design requirements of ordinary residential buildings, while a thickness of 200 mm is suitable for buildings in cold regions or those with higher fire rating requirements.

III. Parameter Determination Principles in Practical Engineering

In practical engineering, the thickness of prefabricated walls should be determined by integrating structural calculation reports and regional construction standards. Structural calculation reports clarify the internal force distribution of walls under vertical and horizontal loads (such as wind loads and seismic actions) through finite element analysis or empirical formulas, thereby determining the minimum thickness requirements. Regional construction standards consider local climatic conditions (e.g., temperature differences, rainfall), geological conditions (e.g., foundation bearing capacity), and construction practices (e.g., modular prefabrication dimensions). For example, in earthquake-prone areas, wall thickness may be appropriately increased to enhance structural ductility; in coastal humid areas, durability requirements may be met by increasing thickness or using anti-corrosion materials.