Cement Prefabricated House Acceptance Form
Currently, there is no single, complete acceptance form specifically tailored for cement prefabricated houses. However, full-process acceptance can be achieved by combining relevant forms, with specific forms to be used in stages and acceptance items adjusted accordingly.
Acceptance of cement prefabricated houses should cover three core aspects: raw materials, component production, and on-site installation. Due to the lack of a unified template, it is necessary to combine the functions of different forms for use. The following are specific operational suggestions:
Stage 1: Raw Material Acceptance - Use the Cement On-site Acceptance and Retest Record Form (2026 Edition) This form is designed in accordance with the GB 50204-2015 standard, focusing on verifying the type of cement (such as ordinary Portland cement), strength grade (such as 42.5 grade), manufacturer qualifications, and whether the quantity on-site matches the contract. It requires recording the production batch number and retest results (such as setting time and compressive strength), and must be signed and confirmed by the construction unit and supervision unit. This step ensures that the quality of raw materials for prefabricated components meets standards, preventing component cracking or insufficient strength due to cement performance defects.
Stage 2: Component Production Acceptance - Refer to the Sample Prefabricated Component Acceptance Record Form Template This form is for the initial production of concrete prefabricated components. It requires checking whether the production plan includes key parameters such as mold accuracy and curing system; whether the quality assurance documents include steel inspection reports and concrete mix design documents; and whether the production process summary clearly specifies pouring sequence and vibration methods. Acceptance must be signed by four levels: the production department, quality inspection department, chief engineer, and unit technical leader, ensuring that the component production process is controllable. For example, the deviation in the thickness of the steel reinforcement protective layer of prefabricated wall panels must be controlled within ±3mm, and actual measurement data can be recorded in this form.
Stage 3: On-site Installation Acceptance - Adjust and Use the House Acceptance Form (General Items) The general form includes physical acceptance items such as doors, windows, walls, and floors, and requires supplementary content specific to the characteristics of prefabricated houses: Door and Window Acceptance: Check the connection and sealing between the prefabricated exterior wall panels and the door and window frames, and whether the sealing strips are intact without breaks; Wall Acceptance: Focus on verifying whether the joints of prefabricated wall panels are flat, whether the joint width deviation is ≤5mm, and whether there is any misalignment; Floor Acceptance: Confirm whether the floor slope after the installation of prefabricated floor slabs meets drainage requirements (such as a bathroom slope ≥1%). It should be noted that the general form does not distinguish between prefabricated and cast-in-place parts. Therefore, items related to cast-in-place concrete (such as formwork removal acceptance) should be deleted, and acceptance content for the connection nodes of prefabricated components should be added.
Notes on Combined Use: Basic information such as project name and construction unit must be filled in for forms at each stage to ensure data correlation; Acceptance personnel should possess corresponding qualifications, such as supervision engineers holding registration certificates; All forms must be archived for future reference as evidence for project quality traceability. By combining the above forms, a systematic full-process acceptance of cement prefabricated houses from raw materials to finished products can be achieved.
