Can Container Houses Have Wallpaper?

Container houses can have wallpaper. The method of applying wallpaper to container houses is similar to that of traditional houses, but there are also some special considerations. Here is a detailed introduction:

I. Preparation

1. Wall conditions: Ensure that the wall is clean, flat, and smooth. The walls of container houses may have some special conditions, such as dents or cracks caused by transportation or installation. These need to be repaired first. Use appropriate materials to fill the dents and repair the cracks, and then sand them flat after they dry. At the same time, thoroughly remove dust, oil stains, and other impurities on the wall to avoid affecting the adhesion of the wallpaper.
2. Base treatment: When applying wallpaper indoors in residential container houses in 2024, there are high requirements for the wall base. The wall should be dry, have sufficient bearing capacity and water absorption capacity, and be kept clean, neutral, and smooth. Plasterers usually carry out construction according to the standard of one layer of gypsum, two layers of putty, and then sanding. The quality of base treatment directly affects the decorative effect of the wallpaper. If the base treatment is improper, problems such as blistering and peeling of the wallpaper may occur.

II. Measurement and cutting Measure the length and width of the wallpaper required according to the size of the walls of the container house. When cutting the wallpaper, reserve a certain margin to deal with possible irregularities on the wall and ensure that the wallpaper can completely cover the wall.

III. Preparation of adhesive Choose an adhesive suitable for the wallpaper material and the walls of the container house. Mix the adhesive according to its instructions to ensure that the concentration of the adhesive is appropriate, so as to ensure that the wallpaper can be firmly attached to the wall.

IV. Application of adhesive Use appropriate tools, such as a brush or a roller, to evenly apply the adhesive to the back of the wallpaper. Pay attention to the thickness of the adhesive when applying it. Avoid applying it too thickly or too thinly. Applying it too thickly may cause the wallpaper to be unevenly attached, while applying it too thinly may affect the firmness of the attachment.

V. Application of wallpaper Carefully attach the wallpaper with the applied adhesive to the wall, starting from one end and gradually unfolding it towards the other end. At the same time, use a scraper or a clean cloth to drive out the air bubbles and wrinkles on the surface of the wallpaper to make it closely fit the wall.

VI. Adjustment and trimming After the wallpaper is applied, check whether the edges of the wallpaper are neat. If necessary, use a knife to trim it so that it perfectly fits the edges of the wall.

VII. Flattening and cleaning Finally, use a pressing roller or a clean cloth to flatten the wallpaper to ensure that there are no air bubbles between the wallpaper and the wall. At the same time, clean the residual adhesive on the surface of the wallpaper to keep the wall clean.